C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
Alternator: Service and Repair
Generator Pulley Replacement
REMOVAL PROCEDURE
1. Remove the drive belt.
2. Install a T-50 TORX(R) bit into the generator shaft.
3. Remove the generator shaft nut and washer.
4. Remove the generator pulley.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the generator pulley, washer and shaft nut.
Tighten
Tighten the generator shaft nut to 75 N.m (55 lb ft).
2. Install the drive belt.