C 3500 HD Truck 2WD V8-8.1L VIN G (2002)
Hydraulic Fluid Accumulator: Service and Repair
Hydraulic Brake Booster Accumulator Replacement
^
Tools Required
-
J 26889 Accumulator Piston Compressor
Removal Procedure
Caution:
^
The accumulator contains compressed gas. Always use the proper tools and follow the recommended procedures or personal injury may
result. Do not apply heat to accumulator. Do not attempt to repair an inoperative accumulator. Always replace an inoperative
accumulator with a new one. Dispose of an inoperative accumulator by drilling a 1.5 mm (1/16 In) diameter hole through the end of the
accumulator can, opposite the O-ring.
^
Push rod remove is not recommended. Improper staking of the push rod to the Hydroboost reaction piston can result in a loss of brakes.
If the rod or seals require service, the entire unit must be replaced.
1. Depress brake pedal at least 10 times to relieve pressure in the accumulator.
2. Remove the master cylinder but do not disconnect the hydraulic brake pipes. Support the master cylinder.
3. Place the J 26839 over the end of the accumulator.
4. Install the nut on the stud.
5. Depress the accumulator with a C-clamp. If accumulator doesn't move with moderate pressure, remove the C-clamp and depress brake pedal 10
times to relieve pressure in the accumulator.