C 3500 HD Truck 2WD V8-8.1L VIN G (2002)
4. Remove the valve rocker arm cover bolts.
5. Remove the valve rocker arm cover.
Important: Valve rocker arm cover gaskets are reusable. Replace the valve rocker arm cover gasket only if damaged.
6. Inspect the valve rocker arm cover gasket for cuts or damage.
7. If replacing the valve rocker arm cover, remove the CPA retainers at the ignition coils.
8. Remove the ignition coil wiring harness bolts.
9. Disconnect the ignition coil electrical connectors.
10. Remove the ignition coil wiring harness.
11. If replacing the valve rocker arm cover, remove the ignition coil bolts.
12. Remove the ignition coil.
Installation Procedure
1. If replacing the valve rocker arm cover, install the ignition coil.
Notice: This bolt is a self-tapping bolt. If installing this bolt into a new component, installation of the bolt may be difficult. Ensure that the bolt is not
over-torqued during the initial installation (thread cutting). Failure to limit torque can lead to bolt failure.
Notice: Refer to Fastener Notice in Service Precautions.