C 3500 HD Truck 2WD V8-8.1L VIN G (2002)
6. Install the engine front cover bolts.
Notice: Refer to Fastener Notice in Service Precautions.
7. Tighten the engine front cover bolts.
7.1.
Tighten the engine front cover bolts in sequence a first pass to 6 Nm (54 inch lbs.).
7.2.
Tighten the engine front cover bolts in sequence a final pass to 12 Nm (106 inch lbs.).
8. Inspect the CMP sensor O-ring for cuts, cracks, tears or damage. Replace the O-ring as needed.
9. Apply a light film of clean engine oil to the CMP sensor O-ring.
10. Install the CMP sensor.
Notice: This bolt is a self-tapping bolt. If installing this bolt into a new component, installation of the bolt may be difficult. Ensure that the bolt is not
over-torqued during the initial installation (thread cutting). Failure to limit torque can lead to bolt failure.
11. Install the camshaft position bolt.
Tighten the camshaft position sensor bolt to 12 Nm (106 inch lbs.).
12. Install the crankshaft balancer.
13. Install the water pump.
14. Raise and suitably support the vehicle with safety stands. Refer to Vehicle Lifting.
15. Tighten the oil pan bolts.
15.1.
Tighten the oil pan bolts a first pass to 10 Nm (89 inch lbs.).
15.2.
Tighten the oil pan bolts a final pass to 25 Nm (18 ft. lbs.).
16. Lower the vehicle.
17. Fill the crankcase with new engine oil.
