C 3500 HD Truck 2WD V8-8.1L VIN G (2002)
Brake Light Switch: Service and Repair
Stop Lamp Switch Replacement
Removal Procedure
1. Remove the pushrod retainer from the brake pedal pin.
2. Remove the stop lamp switch from the pushrod.
3. Disconnect the electrical connector from the stop lamp switch.
Installation Procedure
1. Connect the electrical connector to the stop lamp switch.
2. Install the stop lamp switch onto the pushrod.
3. Install a new pushrod retainer on the brake pedal pin. Use an 11 mm (7/16 inch) socket in order to push a new clip onto the pin.