C 3500 Truck 2WD V8-393 6.5L DSL VIN P (1995)
4. Lock or key.
5. Adjusting nut.
6. Washer.
7. Hub and drum, or hub and rotor.
INSPECT
-
For any worn or damaged parts. Replace any part which appears defective.
INSTALL OR CONNECT
1. Hub and drum, or hub and rotor to the tube.
-
Be sure the bearings and the oil seal are positioned properly.
-
Apply a light coat of high melting point EP bearing lubricant to the contact surfaces and the outside of the axle tube.
2. Washer.
-
Engage tang in keyway.
3. Adjusting nut.
TIGHTEN
-
Adjusting nut to 68 Nm (50 lbs. ft.) while turning the hub.
-
Back off locknut and retighten to 41 to 54 Nm (30 to 40 lbs. ft.) while hub is rotated.
-
Back off nut 135 degrees to 150 degrees.
-
Final bearing adjustment is 0.025 to 0.25 mm (0.001 to 0.010 inch).
4. lockwasher and outer locknut.
-
Bend one ear of the lockwasher over inner nut 30 degrees minimum.
TIGHTEN
-
Nut to 68 Nm (65 lbs. ft.).
5. Axle shaft.
6. Tire and wheel assembly.
-
Lower the vehicle.