C 3500 Truck 2WD V8-393 6.5L DSL VIN P (1995)
REAR CABLES
Rear Parking Brake Cable
Remove or Disconnect
1.
Release parking brake.
2.
Raise vehicle and support with safety stands.
3.
Loosen nut at the equalizer.
4.
Remove Connector.
5.
Remove Rear brake assembly. Refer to Drum Brake System Brake Drum. See: Drum Brake System/Brake Drum
6. Bend in the retaining fingers at the backing plate.
7. Remove Cable.
Install or Connect
CAUTION: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. General Motors will call out those fasteners that require a replacement after removal. General Motors will also call out the fasteners
that require thread lockers or thread sealant. Unless otherwise specified, do not use supplemental coatings (paints, greases, or other corrosion
inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force,
and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can
help you avoid damage to parts and systems.
1.
Install Cable.
2.
Attach cable end into backing plate.
^
Make sure all retaining fingers are completely through the backing plate.
3.
Attach Rear brake assembly.
4.
Reconnect Connector.