chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

All Other Service Bulletins for Fuel: > < Fuels - Effect of Volatility on Driveability|Page 3377
Page 1
background image

Pressure Plate: All Technical Service Bulletins
Clutch - Chatter/Shudder on Launch

Number:

91-331-7C

Section:

7C

Date:

MAY 1991

Corp. Bulletin No.: 167303

Subject:

CLUTCH CHATTER/SHUDDER ON LAUNCH

Model and Year:

1988-91 C2,C3,K2,K3 TRUCKS WITH 4-SPEED MANUAL TRANSMISSION AND 7.4L ENGINE

Some 1988-91 C2, C3. K2 AND K3 trucks equipped with 7.4L engines with 4-speed manual transmissions may experience a condition of chatter or
shudder on launch.

Revised clutch discs and matching pressure plates have been released for these vehicles and are available through GMSPO. The clutch discs feature a
revised facing material which will provide smoother engagement and increased wear resistance. These revised discs can be identified by the name stamp
Valeo while the previous discs were stamped Borg Wamer. The pressure plates have been revised to work with the discs and must be replaced at the
same time. The revised pressure plates will be marked with the name stamp Luk while the previous pressure plate may be marked with the name stamp
Luk or Borg Warner.

The installation of these parts will provide significant improvement in the involved vehicles.

VEHICLES INVOLVED:

Some 1988-91 C2, C3, K2 AND K3 trucks equipped with 7.4L engines and 4-speed transmissions built prior to the following VIN breakpoints may
exhibit the subject condition:

Plant

Fort Wayne (Z)

No Vehicles Involved

Oshawa (1)

M1185747

Pontiac (E)

ME162285

SERVICE PROCEDURE:

The pressure plate and clutch disc should be replaced at the same time as the parts have been designed to work together. Refer to section 7C of the
appropriate service manual for clutch disc and pressure plate replacement procedure.

IMPORTANT:

Before removing the existing pressure plate, note the location of the paint dab on the pressure plate cover. This paint dab indicates the
heavy side of the pressure plate assembly and is aligned with the light side of the engine at the assembly plant. The new pressure plate
should be installed with paint dab in the same location to preserve the balance of the engine assembly.

SERVICE PARTS INFORMATION:

PRESSURE

CLUTCH

ENGINE

TRANSMISSION

PLATE P/N

DISC P/N

7.4L

4-SPEED

15679571

15679572

Parts are currently available from GMSPO.

WARRANTY INFORMATION:

For vehicles repaired under warranty use:

Labor Operation:

K0800

Use applicable labor time guide for labor hours.

All Other Service Bulletins for Fuel: > < Fuels - Effect of Volatility on Driveability|Page 3377