C 3500 Truck 2WD V8-454 7.4L VIN J SFI (1999)
6. Install the ball joint stud nut.
-
Tighten the nuts to 165 Nm (121 ft. lbs.).
-
Tighten the ball joint stud nut to 128 Nm (94 ft. lbs.). Tighten the nut by aligning the slot in the stud nut with the hole in the stud.
Notice: Refer to Fastener Notice in Service Precautions.
Important: Tighten the nuts of the control arm at the proper Z height. Refer to Trim Height Inspection Procedure in Wheel Alignment.
7. Install a new cotter pin.
8. Install the hub and the rotor.
9. Install the tire and wheel assembly.
10. Remove the safety stands.
11. Lower the vehicle.
