C 3500 Truck 2WD V8-6.0L VIN U (2001)
5. Remove the tire and wheel assembly.
6. Inspect the caliper operation.
Notice: Support the brake caliper with heavy mechanic's wire, or equivalent, whenever it is separated from it's mount and the hydraulic flexible brake
hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may
cause damage to the brake hose and in turn may cause a brake fluid leak.
7. Remove the caliper from the mounting bracket and support the caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the
hydraulic brake flexible hose from the caliper.
8. Inspect the caliper assembly.
9. Remove the brake pads from the brake caliper bracket.
10. Remove and discard the anti-rattle clips from the brake caliper mounting bracket.
Installation Procedure
1. Install the anti-rattle clips to the brake caliper bracket.
2. Install the brake pads to the brake caliper bracket.
^
Install the inner pad (1 wear indicator).
^
Install the outer pad (2 wear indicators).
3. Install the brake caliper to the mounting bracket.
4. Install the tire and wheel assembly.
5. Remove the safety stands.
6. Lower the vehicle.
7. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
8. Slowly release the brake pedal.
9. Wait 15 seconds, then repeat steps 7-8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
10. Fill the master cylinder reservoir to the proper level with clean brake fluid.
11. Burnish the brakes pads and rotors as necessary.
