C 3500 Truck 2WD V8-6.0L VIN U (2001)
Brake Master Cylinder: Service and Repair
Master Cylinder Reservoir Filling
Master Cylinder Reservoir Filling
Notice: When adding fluid to the brake master cylinder reservoir, use only Delco Supreme 110 (GM P/N 12377967) or equivalent DOT-3 brake fluid
from a clean, sealed brake fluid container. The use of any type of fluid other than the recommended type of brake fluid, may cause contamination
which could result in damage to the internal rubber seals and/or rubber linings of hydraulic brake system components.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Service Precautions.
1. Visually inspect the brake fluid level through the brake master cylinder reservoir.
2. If the brake fluid level is at or below the half-full point during routine fluid checks, the brake system should be inspected for wear and possible
brake fluid leaks.
3. If the brake fluid level is at or below the half-full point during routine fluid checks, and an inspection of the brake system did not reveal wear or
brake fluid leaks, the brake fluid may be topped-off up to the maximum-fill level.
4. If brake system service was just completed, the brake fluid may be topped-off up to the maximum-fill level.
5. If the brake fluid level is above the half-full point, adding brake fluid is not recommended under normal conditions.
6. If brake fluid is to be added to the master cylinder reservoir, clean the outside of the reservoir on and around the reservoir cap prior to removing
the cap and diaphragm. Use only Delco Supreme 110 (GM P/N 12377967) or equivalent DOT-3 brake fluid from a clean, sealed brake fluid
container.
