C 3500 Truck 2WD V8-6.0L VIN U (2001)
![background image](/chevrolet/c_3500_truck_2wd/v8-6.0l_vin_u/Page-566001.png)
Alignment: Specifications
Ride/Trim Height Inspection Procedure
Trim Height Measurements
Trim height is a predetermined measurement relating to vehicle ride height. Incorrect trim heights can cause bottoming out over bumps, damage to the
suspension components and symptoms similar to wheel alignment problems. Check the trim heights when diagnosing suspension concerns and before
checking the wheel alignment. Perform the following before measuring the trim heights:
1. Set the tire pressures to the pressure shown on the certification label. Refer to Label - Vehicle Certification (who RPO Z49) or Label - Vehicle
Certification (w/ RPO Z49).
2. Check the fuel level. Add additional weight if necessary to simulate a full tank.
3. Make sure the rear compartment is empty except for the spare tire.
4. Make sure the vehicle is on a level surface, such as an alignment rack.
5. Close the doors.
6. Close the hood.
7. All dimensions are measured vertical to the ground. Trim heights should be within 13 mm (0.5 inch) to be considered correct.
Z Height Measurement
Important: K models only the Z height must be adjusted before the alignment.
The Z height dimension measurement determines the proper ride height for the front end of the vehicle. Vehicles equipped with torsion bars use a
adjusting arm in order to adjust the Z height dimension. Vehicles without torsion bars have no adjustment and could require replacement of suspension
components.
1. Lift the front bumper of the vehicle up about 38 mm (1.5 inch).
2. Gently remove your hands.
3. Allow the vehicle to settle into position.
4. Repeat this jouncing operation 2 more times for a total of 3 times.
5. Measure from the pivot bolt center line (3) down to the lower corner (5) of the lower ball joint (1 ) in order to obtain the Z height measurement
(4).
6. Push the front bumper of the vehicle down about 38 mm (1.5 inch).
7. Gently remove your hands.
8. Allow the vehicle to rise.
9. Repeat the operation for a total of 3 times.
10. Measure the Z dimension.
11. The true Z height dimension number is the average of the high and the low measurements. Refer to Trim Height Specifications.
Z Height Adjustment