Camaro V6-173 2.8L (1983)
FIGURE 2
8.
Insert a 1/4 inch flat blade screw driver through the opening in the center of the caliper bridge and insert the blade into the dust boot groove of the
caliper piston (See Figure 2).
NOTICE:
BE CAREFUL NOT TO DAMAGE THE DUST BOOT WHEN
INSERTING THE SCREW DRIVER BLADE.
9.
Prying against the caliper opening, exert sufficient pressure on the piston to hold the inner brake pad against the rotor. While holding the piston in
this position with one hand and the .010" - .015" shim with the other hand, have the park brake applied and released three (3) times.