chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Engine - Hesitation on Light Acceleration|Page 2841 > < Canister Purge Solenoid|Locations|Page 2836
Page 1
background image

Evaporative Emission Control Canister: Technical Service Bulletins
Engine - Hesitation on Light Acceleration

Number:

86-238

Section:

6E

Date:

MAY, 1987

Subject:

DRIVEABILITY - WARM HESITATION

Model and Year:

1982-86 PASSENGER CARS WITH 5.0L (V.I.N. CODE H) ENGINE

1984-86 PASSENGER CARS WITH 5.0L (V.I.N. CODE G) ENGINE

TO:

ALL CHEVROLET DEALERS

Some vehicles with the above engines may experience a hesitation on a light acceleration.  This hesitation is normally seen after an extended idle or a
short hot soak in higher ambient temperatures.  This condition could be caused by excessive fuel vapor entering the engine through the canister purge
system. To determine if the hesitation is from the purge system the following test should be performed:

1.

Vehicle should be at normal operating temperature.

2.

On 1982-85 models plug canister purge at Y connector in crankcase vent line. On 1986 models plug canister purge at carburetor.

3.

Test Drive Vehicle;

a.

Hesitation still present, look for other reasons for hesitation (accelerator pump, timing, etc.).

b.

Hesitation no longer present, install fuel vapor canister control kit, P/N 10077501 per instruction in kit.

4.

Reconnect purge system.

Labor Operation No:

T1200

Labor Time        :

.5 Hours

Engine - Hesitation on Light Acceleration|Page 2841 > < Canister Purge Solenoid|Locations|Page 2836