Camaro V8-305 5.0L VIN F FI (1985)
FIGURE 2
To repair this condition, disassemble the transmission and clutch housing assembly from the vehicle and measure the amount of protrusion for both
pins. Each pin should have a minimum of 8.8 mm (.35") protrusion. If less than 8.8 mm the pins should be removed from the case using an "easy
out" and large tee handle or other similar method. Then install two new 19 mm (.748") long dowel pins P/N 477231 into the block until the pins
protrude 8.8 mm. Use a clutch housing mounting bolt to install the new pins, as shown in Figure 2. Lubricating the pins should ease the installation
process.
Parts are currently available from GMSPO.
NOTICE:
CARE SHOULD BE TAKEN TO AVOID DAMAGE/DEFORMATION TO THE PRECISION MACHINED LOCATING
COUNTERBORES IN THE CYLINDER AND CASE. PARTICULAR CARE SHOULD BE TAKEN TO AVOID CRACKING THE
CYLINDER AND CASE.
Use applicable Labor Operation Number and Labor Time.
