Camaro V8-5.7L VIN G (1998)
Brake Bleeding: Service Precautions
Hydraulic Brake System Bleeding (ABS W/O Traction Control)
Notice:
^
If any brake component is repaired or replaced such that air is allowed to enter the brake system, the entire bleeding procedure must be followed.
^
Use only DOT 3 brake fluid from a clean, sealed container. Do not use any fluid from a container which is wet with water. Do not use DOT 5
silicone brake fluid. Improper brake fluid, mineral oil or water in the fluid may cause the brake fluid to boil or the rubber components to
deteriorate. Keep all fluid containers capped to prevent contamination.
^
Avoid spilling brake fluid on any of the vehicle's painted surfaces, wiring, cables, or electric connectors. Brake fluid will damage the paint and the
electrical connections. If any fluid is spilled on the vehicle, flush the area to lessen the damage.
^
Prior to bleeding the brakes, the front and rear displacement cylinder pistons must be returned to the top most position. The preferred method uses
a Scan Tool to perform the rehoming procedure. If a Scan Tool is not available, the second procedure may be used, but it is extremely important
that the procedure be followed exactly as outlined.
