Camaro V8-5.7L VIN G (1998)
Wheel Bearing: Service and Repair
FRONT WHEEL BEARINGS AND/OR HUB
REMOVAL PROCEDURE
1. Raise and suitably support the vehicle.
2. Remove the special security wheel lock nut, if equipped. Use the special security wheel lock key which is located in the front floor console.
3. Remove the Tire and Wheel. R
4. Remove the brake caliper (3).
5. Remove the brake rotor (5).
6. Disconnect the wheel speed sensor electrical connector and set the connector aside.
7. Remove the bolts/screws (6) from the hub (4).
8. Pull the hub from the spindle.
INSTALLATION PROCEDURE
1. Position the hub (4) to the spindle.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
2. Install the bolts and the screws (6).
Tighten
Tighten the bolts/screws to 86 Nm (63 ft. lbs.).
Important: Ensure that the wheel speed sensor electrical connector is reconnected to the wheel speed sensor wire bracket (8) and to the wheel
speed sensor. Otherwise the wires may be damaged.
3. Connect the wheel speed sensor electrical connector.
4. Install the brake rotor (5).
5. Install the brake caliper (3).
6. Install the tire and the wheel.
7. Install the special security wheel lock nut, if equipped. Use the special security wheel lock key which is located in the front floor console.
8. Lower the vehicle.
