Camaro V8-5.7L VIN G (1998)
Inspect
^
Electrical terminals for corrosion. Remove corrosion or replace component as necessary.
^
Temperature and mode knobs for freedom of movement. Lubricate, repair or replace as necessary.
^
Temperature control cable for kinks, binding and other damage. Adjust, repair or replace as necessary.
Install or Connect
1. Rear defogger switch connector (4).
2. Temperature control cable from control (5).
3. Vacuum harness connector from vacuum selector valve.
4. Blower motor switch connector (3).
5. HVAC control illumination connector (2).
6. HVAC mode switch connector (1).
7. HVAC control.
8. HVAC control bolts.
Tighten
^
HVAC control bolts to 1.9 N.m (17 lb. in.).
9. Accessory trim plate.
Important
^
Test operation of temperature control knob, mode control knob and blower motor switch.
Control Lamp Bulb
Remove or Disconnect
1. Accessory trim plate.
^
Pull accessory trim plate forward and off instrument panel lower trim pad.
2. HVAC control bolts.
3. Control.
^
Pull control out far enough to reach control lamp bulb socket.
4. Bulb and socket by twisting socket.
5. Bulb from socket.
^
Pull bulb straight out from socket.
Inspect
^
Control lamp bulb socket for corrosion and damage. Clean or replace as necessary.
^
Wires for damage and secure connection to bulb socket. Repair or replace as necessary.
Install or Connect
1. New bulb.
^
Push bulb straight into socket.
2. Bulb and socket by twisting socket into place.
3. Control.
4. HVAC control bolts.
Tighten
^
HVAC control bolts to 1.9 N.m (17 lb. in.).
5. Accessory trim plate.
