chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Body - Trunk Lid Binds/Difficult To Open|Page 10063 > < Body - Trunk Latch Binds/Difficult to Open or Close|Page 10058
Page 1
background image

Trunk / Liftgate Latch: All Technical Service Bulletins
Body - Trunk Lid Binds/Difficult To Open

TECHNICAL

Bulletin No.: 10-08-66-001

Date: January 08, 2010

Subject: Rear Compartment (Trunk) Lid Binds and/or Difficult to Open or Close (Replace Latch and Latch Striker, Install Hook and Loop Material)

Models:

2010 Chevrolet Camaro

Condition

Some customers may comment that the rear compartment (trunk) lid won't open or that they need to apply downward pressure to the lid while unlatching
it. The customer may also comment that the lid won't latch even when slammed. This condition may be intermittent. The latch can be released using the
Emergency Trunk Release (ETR) release handle located on the inside of the rear compartment lid.

Cause

This condition may be caused by the latch (located on the rear compartment lid) binding with the latch striker (located on the rear body panel). This
condition may also be caused by the ETR handle binding on the rear compartment lid carpet.

Correction

Use the following steps to replace the rear compartment latch and striker and install hook and loop material to the ETR handle.

1. Replace the rear compartment lid latch. Refer to Rear Compartment Lid Latch Replacement in SI.
2. Replace the rear compartment lid latch striker. Refer to Rear Compartment Lid Latch Striker Replacement in SI.

3. Ensure that the ETR handle is pushed fully toward the latch before the hook and loop material is applied. 

4. Install a 25 mm x 25 mm (1.0 in X 1.0 in) piece of hook and loop material, such as 3M(TM) Scotchmate Hook and Loop Fastening System*,

P/N051131-06480, or the equivalent, to the ETR handle as shown. This will prevent the ETR handle from moving out of position when not in use.

* We believe this source and their products to be reliable. There may be additional manufacturers of such products/materials. General Motors does not
endorse, indicate any preference for, or assume any responsibility for the products or material from this firm or for any such items that may be available
from other sources. 

Body - Trunk Lid Binds/Difficult To Open|Page 10063 > < Body - Trunk Latch Binds/Difficult to Open or Close|Page 10058