Camaro V8-6.2L (2010)
50. Tighten the trailing arm to knuckle retaining bolt (2) and NEW nut (1) to 40 Nm (30 lb ft) and final pass 120 degrees.
Note: Make sure that the vehicle is positioned on a suitable hoist to load the rear suspension bushes to the correct position.
51. Align the marks on the eccentric washers (1) with the marks on the subframe (3).
52. Tighten the adjust link to subframe retaining bolt (2) and NEW nut (4) to 115 Nm (85 lb ft).
53. Correct the wheel alignment of the vehicle, if necessary. Refer to Wheel Alignment Specifications ().
