Camaro V8-6.2L (2010)
Note: Install new brake caliper bolts any time the bolts are removed.
6. Install 2 new brake caliper bolts (1) and tighten to 60 Nm (44 lb ft) + 90 degrees.
7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
8. If the brake rotor was refinished or replaced, or if new brake pads were installed, burnish the brake pads and rotors. Refer to Brake Pad and Rotor
Burnishing (See: Brake Pad/Service and Repair/Procedures).
Rear Brake Rotor Replacement
Rear Brake Rotor Replacement
Special Tools
*
J-41013 - Rotor Resurfacing Kit
*
J-42450-A - Wheel Hub Resurfacing Kit
For equivalent regional tools, refer to Special Tools (See: Tools and Equipment).
Removal Procedure
Warning: Refer to Brake Dust Warning (See: Service Precautions/Technician Safety Information/Brake Dust Warning).
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).
