Camaro V8-6.2L (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the brake rotor bolt (1) and tighten to 10 Nm (89 lb in).
5. Position the brake caliper assembly to the suspension knuckle.
Note: The brake caliper bolts must be replace any time they are removed.
6. Install 2 new brake caliper bolts (1) and tighten to 40 Nm (30 lb ft) +90 degrees.
7. Inspect the parking brake adjustment. Refer to Parking Brake Adjustment (See: Parking Brake System/Adjustments).
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
9. If the brake rotor was refinished or replaced, or if new brake pads were installed, burnish the brake pads and rotors. Refer to Brake Pad and Rotor
Burnishing (See: Brake Pad/Service and Repair/Procedures).
