Camaro V8-6.2L (2010)
6. Compress the timing chain tensioner guide and install the EN 46330.
Note:
*
Properly locate the CMP actuator onto the locating pin of the camshaft.
*
The sprocket teeth and timing chain teeth must mesh.
*
The camshaft and the crankshaft sprocket alignment mark MUST be aligned properly.
*
Do not use the CMP solenoid valve again. Install a NEW valve during assembly.
7. Identify the alignment hole (1) in the rear face of the CMP actuator and the locating pin (2) on the front face of the camshaft.