Camaro V8-6.2L (2010)
Note:
*
Do not reuse the crankshaft oil seal or rear cover gasket.
*
Do not apply any type of sealant to the rear cover gasket, unless specified.
*
The special tool in this procedure is used to properly center the crankshaft rear oil seal.
*
All gasket surfaces should be free of oil or other foreign material during assembly.
*
The crankshaft rear oil seal MUST be centered in relation to the crankshaft.
*
An improperly aligned rear cover may cause premature rear oil seal wear and/or engine assembly oil leaks.
1. Apply a 5 mm (0.2 in) bead of sealant, 20 mm (0.8 in) to the 2 joints (a) at the rear of the block/pan. Refer to Adhesives, Fluids, Lubricants, and
Sealers (See: Specifications/Adhesives, Fluids, Lubricants, and Sealers).
