Camaro V8-6.2L (2010)
Blower Motor: Service and Repair
Blower Motor Replacement
Blower Motor Replacement
Removal Procedure
1. Remove the instrument panel compartment assembly. Refer to Instrument Panel Compartment Replacement (See: Body and Frame/Interior
Moulding / Trim/Glove Compartment/Service and Repair/Instrument Panel Compartment Replacement).
2. Remove screws that attach lower portion of plastic instrument panel glove box opening.
3. Pull lower portion of plastic instrument panel glove box opening away from metal mounting points enough to remove screws holding right side
heater duct in place.
4. Remove the right side floor heater duct. Floor Front Air Outlet Duct Replacement (See: Air Duct/Service and Repair/Floor Front Air Outlet Duct
Replacement).
5. Remove the blower motor cover. Blower Motor Cover Replacement (See: Blower Motor Cover Replacement).
6. Remove the blower motor wire harness connector.
Note: Blower motor is molded into HVAC module case during manufacturing process, therefore HVAC module case must be cut to remove
blower. Cut through the case as straight as possible because the motor cup must be reused. In order to prevent damage to the component, do not
cut any deeper than necessary to remove the motor cup.
7. Cut out the blower motor using a utility knife in the narrow groove of the lower case.