Camaro V8-62L (2010) - Backup Lamp Switch - Service and Repair
Backup Lamp Switch: Service and Repair
Tremec 6-Speed - Manual Transmission
Backup Lamp Switch Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair)
2. Disconnect the backup lamp switch electrical connector (3).
3. Remove the backup lamp switch wire harness from the bracket.
4. Using a Snap-On(TM)VSM5222 22 mm angle head open end wrench, or equivalent, remove the backup lamp switch (2).
Installation Procedure
1. Apply pipe sealant with Teflon(R) to the threads of the backup lamp switch. Use GM P/N 1052080 or equivalent.
