Camaro V8-6.2L (2010)
3. Ignition ON, connect a 3 A fused jumper wire between the MIL control circuit terminal X1-68 and ground. The MIL should illuminate.
‹› If the MIL does not illuminate, test the MIL control circuit for a short to voltage, or an open/high resistance. If the circuit tests normal, replace
the P16 IPC/bulb.
4. If all circuits/connections test normal, replace the K20 ECM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests and Procedures) after completing the diagnostic procedure.
*
Instrument Cluster Replacement (See: Instrument Panel, Gauges and Warning Indicators/Compass/Service and Repair)
*
Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming