Camaro V8-6.2L (2010)
Auxiliary Power Outlet: Testing and Inspection
Power Outlet Receptacle Inoperative (120 VAC)
Power Outlet Receptacle Malfunction
Diagnostic Instructions
*
Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
*
Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
*
Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure Instructions)
provides an overview of each diagnostic category.
Diagnostic Fault Information
Circuit/System Description
The accessory power receptacles are supplied B+ when the ignition is on or in the accessory position.
Reference Information
Schematic Reference
Cigar Lighter/Power Outlet Schematics (See: Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Power Outlets Description and Operation (See: Description and Operation)
Electrical Information Reference
*
Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
*
Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Connector
Repairs/Connector Repairs)
*
Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
*
Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Circuit/System Verification
Install a 12 V DC accessory into an X80 accessory power receptacle. Ignition ON, command the Accessory/Retained Accessory Power Relay Command
ON and OFF with a scan tool. The K10 RAP relay should click and the 12 V DC accessory should have power.
Circuit/System Testing
1. Ignition OFF, disconnect the K10 RAP relay.
2. Test for less than 10 ohm between the ground circuit terminal 86 and ground.
‹› If greater than the specified range, test the ground circuit for an open/high resistance.
