Camaro V8-6.2L (2010)
8. Inspect the EL-38826 - harness and the appropriate pigtail adapter (2) for damage. Replace as needed.
9. Short the 2 SIR deployment harness leads (1) together using one banana plug seated into the other.
10. Connect the appropriate pigtail adapter (2) to the SIR deployment harness (1).
11. Extend the SIR deployment harness and adapter to the full length from the deployment fixture or area.
Note: On a dual stage air bag, both connectors must be attached to the deployment harness adapter. This will ensure that both stage 1 and stage 2
of the deployment loops are energized, regardless of the deployment state.
12. Connect the air bag (1) to the adapter (2) on the SIR deployment harness (3).
Note:
*
The rapid expansion of gas involved with deploying an air bag is very loud. Notify all the people in the immediate area that you intend to
deploy the air bag.
*
When the air bag deploys, the deployment fixture may jump about 30 cm (1 ft) vertically. This is a normal reaction of the air bag due to the
force of the rapid expansion of gas inside the air bag.
*
If you are deploying a dual stage air bag with stage 1 already deployed, the fixture may not move and the noise may have been reduced.
13. Clear the area of people.
