Camaro V8-6.2L (2010)
Parts Information
The engine wiring harness tape will be shipped at no charge via UPS Overnight Delivery Attention: Parts Manager, beginning Tuesday, May 5, 2009.
All dealers should have tape at their dealership no later than Monday, May 11, 2009. Additional tape, if needed, is to be obtained by calling the
Technical Assistance Center (TAC).
All other parts required to complete this recall are to be obtained from General Motors Service and Parts Operations (GMSPO). Please refer to your
"involved vehicles listing" before ordering parts. Normal orders should be placed on a DRO = Daily Replenishment Order. In an emergency situation,
parts should be ordered on a CSO = Customer Special Order.
Service Procedure
Note
If the vehicle had previously been repaired with the temporary fix (labor code T5728), perform Steps 8-8.4 only. Submit a claim using labor code
V2078. If the vehicle has NOT had the temporary fix, perform all steps in the service procedure.
1. Disconnect negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in SI.
2. Lift and support vehicle. Refer to Lifting and Jacking the Vehicle in SI.
3. Remove the starter shield from the vehicle. Refer to Starter Shield Replacement in SI.
4. Locate where the battery positive starter cable (3) contacts the starter (4) and motor mount (5). Refer to the illustration above.
5. Remove starter terminal nut and the battery starter cable from the starter terminal.
6. Move the battery starter cable away from the motor mount.
