Camaro V8-6.2L (2010)
27. Remove the trailing arm to subframe retaining bolt (2) and nut (1).
Discard the nut.
28. Remove the drive shafts. Refer to Rear Wheel Drive Shaft Replacement (See: Transmission and Drivetrain/Drive Axles, Bearings and
Joints/Axle Shaft Assembly/Service and Repair).
29. Remove the trailing arm.
30. Remove the differential. Refer to Differential Replacement ().
Note: The adjust link to subframe retaining bolt (2), nut (5) and eccentric washers (1) are used to adjust the rear suspension toe. One eccentric
washer (1) is mounted directly to the head of the adjust link to subframe retaining bolt (2).
31. Mark the eccentric washers (1) with reference to their seating position relative to the subframe (4).
Note: Fasteners with thread sealant must be discarded after removal.
Discard the nut.
Remove the adjust link to subframe retaining bolt (2) and nut (5).
32. Remove the adjust link (3) from the subframe (4).
