Camaro V8-6.2L (2010)
16. Connect the rear strut assembly (4) to the lower control arm (3).
Note: Do not fully tighten the lower control arm to strut assembly retaining bolt (2) and nut (1) at this stage.
17. Install the lower control arm to strut assembly retaining bolt (2) and NEW nut (1).
Do not fully tighten at this stage.
18. Install the rear wheel hub and knuckle assembly. Refer to Knuckle Replacement (See: Rear Knuckle/Service and Repair/Rear Suspension) in rear
Suspension.
19. Install the stabilizer shaft. Refer to Stabilizer Shaft Replacement (See: Stabilizer Bar/Service and Repair/Rear Suspension).
20. Install the stabilizer shaft link. Refer to Stabilizer Shaft Link Replacement (See: Stabilizer Bar/Stabilizer Link/Service and Repair/Rear
Suspension).
Note: Make sure the intermediate brake cable is clear of the rear frame to body mount prior to securing the frame retaining bolts.
21. Lower the vehicle to the frame.
22. Index the rear side frame mounts to the rear locator sleeves located on the body.
23. Lower the vehicle until the frame mounts contact the body rail.
24. Install the rear sub frame to rear chassis rail retaining bolts and tighten to 100 Nm (74 lb ft) and a final pass of 110 degrees.
25. Raise the vehicle.
26. Remove the frame support table from under the vehicle.
