chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Rear Cross-Member|Service and Repair|Page 8330 > < Rear Cross-Member|Service and Repair|Page 8328
Page 15
background image

36. Install the outer cable (4) to the vehicle underbody bracket (3).

Make sure that the outer cables (4) are properly seated in the vehicle underbody bracket (3).

Note:  Wrap a workshop cloth around the rear inner cable (1) to protect it from damage. Using pliers, pull the rear inner cable (1) forward and
downwards to install the ball nipple to the front park brake cable and equalizer bracket assembly (2).

37. Install the rear inner cables (1) to the front park brake cable and equalizer bracket assembly (2).
38. Install the differential. Refer to Differential Replacement   ().
39. Install the drive shafts. Refer to Rear Wheel Drive Shaft Replacement   (See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle

Shaft Assembly/Service and Repair).

40. Install the rear strut assembly. Refer to Shock Absorber Replacement   (See: Suspension Strut / Shock Absorber/Service and Repair/Rear

Suspension Shock Absorber).

41. Install the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement   (See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings

and Joints/Drive/Propeller Shaft/Service and Repair/Two-Piece Propeller Shaft Replacement).

42. Install the exhaust system. Refer to Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement   (See: Engine, Cooling and

Exhaust/Exhaust System/Muffler/Service and Repair/Exhaust Muffler with Resonator, Exhaust, and Tail Pipe Replacement).

43. Install the rear wheel. Refer to Tire and Wheel Removal and Installation   (See: Wheels and Tires/Service and Repair).
44. Lower the vehicle to the ground.
45. Bounce the vehicle several times to settle the suspension.

Rear Cross-Member|Service and Repair|Page 8330 > < Rear Cross-Member|Service and Repair|Page 8328