Camaro V8-6.2L (2010)
Clutch Slave Cylinder: Service and Repair
Clutch Concentric Actuator Cylinder Replacement
Removal Procedure
1. Remove the manual transmission from the vehicle. Refer to Transmission Replacement (See: Manual Transmission/Transaxle/Service and
Repair/Removal and Replacement/Tremec 6-Speed - Manual Transmission/Transmission Replacement).
2. Disconnect the pipe fitting (1) from the clutch slave cylinder.
3. Remove the clutch slave cylinder bolts (3).
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the clutch slave cylinder and bolts (3) and tighten to 13 Nm (115 lb in).
