Camaro V8-6.2L (2010)
Front Door Window Glass Weatherstrip: Technical Service Bulletins
Body - Front Side Door Window Squeaking Noise
TECHNICAL
Bulletin No.: 09-08-64-026
Date: June 22, 2009
Subject: Front Side Door Window Squeaking Noise, Reversal During Express Up (Align/Replace Weatherstrip)
Models:
2010 Chevrolet Camaro
Built Before VIN Breakpoint A9114092
Condition
Some customers may comment about a squeaking noise coming from the front area of the door when raising or lowering the front side door window. On
some vehicles, the window may also reverse direction when using the express up feature.
Cause
Important:
Do not replace the door window, window regulator or window regulator motor to correct this condition. These conditions may be caused by the front
door front run channel weatherstrip (outside rearview mirror seal) being inverted and folded forward by the inner beltline seal.
Correction
Use the following steps to correct the condition.
1. Remove the front side door trim panel on the affected door. Refer to Front Side Door Trim Panel Replacement in SI.
2. Remove the three screws that retain the exterior mirror patch. It is not necessary to completely remove the mirror patch.
3. Using a trim stick, reposition the front door run channel weatherstrip on the door to remove any twists or bows. Also inspect the seal for any splits or
tears in the area that was out of alignment.
4. Ensure the gap between the inner and outer seal is even and the surfaces are parallel.