Camaro RS V8-305 5.0L VIN E TBI (1990)
3.
Refer to Figure 9. Remove cable assembly from latch hole in number five bow latch and cable support bracket.
4.
Remove support clips and cable. Support clips will be re-used.
5.
Remove bezel housing nuts and bezel housing with cable. Discard old bezel housing cable assembly.
6.
Kit P/N 12517351 includes bezel housing, cable assembly, handle assembly (slide and stem), slide nut and slide bolt. This kit must be assembled.
7.
Feed cable wire bead through bezel housing and attach plastic cable assembly to housing.
8.
Slide stem into bezel housing and place cable wire bead into recess of stem. Pull cable from opposite end for tension.
9.
Attach bezel and nuts to tonneau.
10.
Align cable assembly and clips to tonneau mounting holes and attach.