Camaro Z28 V8-305 5.0L VIN F FI (1991)
is recommended if additional sealing material is required.
When access to the inner panel is required to perform service operations, the deflector may be completely or partially detached from the inner panel. If
the existing water deflector is damaged so that it will not properly seal the door, replace the deflector. The water deflector is available as a service part.
The following procedure covers complete removal and installation of the water deflector. If only partial removal of the deflector is required, perform
only those steps which are necessary to expose the required area of the door inner panel.
Water Deflector
REMOVE OR DISCONNECT
l.
Door trim panel.
2. Water deflector (47).
^
Use a flat-bladed tool to break the sealer bond between the water deflector (47) and the door inner panel.
3. Tape from the door inner panel, carefully.
4. Water deflector (47) from the door inner panel drain slot.
5. Water deflector (47).
INSPECT
^
Water deflector (47) for tears or holes. Repair tears or holes using waterproof body tape on both sides of the water deflector (47).
INSTALL OR CONNECT
1. Water deflector (47).
^
Apply a string sealer in a continuous bead that will guide water to the drain slots.
^
Insert the water deflector tabs in the door inner panel.
^
Firmly press the edges of the water deflector (47) to obtain a good bond between the water deflector sealer and the door inner panel.
^
Apply body caulking to any screw heads or piercings in the door inner panel below the water deflector (47).
2. Door trim panel.
Window Guide Cam
