Caprice Wagon V8-305 5.0L (1986)
FIGURE 2
8.
Remove air horn screws number 6 and 7 from carburetor. Refer to Figure 2.
9.
Turn carburetor over and remove:
a.
Throttle body to float bowl attachment screws.
b.
Throttle body from carburetor.
c.
Pipe plug from rear of throttle body.
d.
Float bowl to throttle body gasket.
10.
Disconnect and remove Accelerator pump link from throttle body.
11.
Install:
a.
New float bowl to throttle body gasket on carburetor. (New gasket is supplied in throttle body kit. Refer to parts information in this bulletin.)
b.
Accelerator pump link to new throttle body.
c.
New throttle body to carburetor.
d.
Throttle body to float bowl attachment screws and tighten screws.
12.
Turn carburetor over. Install and tighten two air horn screws previously removed and tighten all other air horn screws in the sequence shown.
Refer to Figure 2.
FIGURE 1
13.
Connect accelerator pump link to pump lever and install retainer. Refer to Figure 1.
14.
Using tool J29030-B, BT-7610B, or equivalent, turn both mixture needles clockwise until lightly seated.
15.
Turn each mixture needle counterclockwise 3 turns.
16.
Clean carburetor sealing surface on intake manifold and install carburetor with new flange (base) gasket supplied in throttle body kit.
