Caprice Wagon V8-350 5.7L (1994)
Cruise Control Module: Service and Repair
Fig. 36 Cruise Control Module Removal
1. Disconnect battery ground cable.
2. Disconnect electrical connector from module, Fig. 36.
3. Disconnect cruise control cable from module, then remove bolts and screws.
4. Remove module and plugs.
5. Remove plugs from module if a new module is being installed.
6. Reverse procedure to install noting the following:
a. Align holes in accelerator and cruise control adjuster bracket to holes in wheel house panel and position module on wheel house panel.
b. Torque module bolts and screws to 71 ft. lbs.
c. Adjust cable, if necessary.
