Caprice Wagon V8-350 5.7L (1994)
Ignition Control Module: Service and Repair
Ignition Coil Assembly
Remove or Disconnect:
1. Disconnect negative battery cable
2. Disconnect four terminal PCM connector at coil driver
Coil And Coil Module Removal And Installation
3. Disconnect coil connectors
4. Disconnect secondary wire
5. Remove bolt and stud
6. Remove ignition coil module (ICM), driver, and bracket
Install or Connect:
1. Spread silicone grease on the metal face of the ICM mounting bracket. This grease is necessary for ICM cooling.
2. Install coil driver and module
3. Tighten bolt and stud to specification
Torque Value:
25 N-m (18 lb.ft.)
4. Connect secondary wire
5. Connect four terminal connector to coil driver