Caprice Wagon V8-350 5.7L VIN P SFI (1996)
6. Connect the fuel feed hose (3) to the fuel pump outlet.
-
Tighten the clamp (4) so that 5 to 8 teeth are engaged.
7. Connect the fuel pump electrical connector and the electrical connector to the bottom of the sender cover.
8. Install the terminal retainer.
Important: Always install a new pump strainer when replacing the fuel pump.
9. Install a new fuel pump strainer in the same position as noted during disassembly.
-
Push on the outer edge of the strainer ferrule until the strainer is fully seated.
10. Install the fuel sender assembly:
A. Position the new gasket (4) on the fuel tank (5).
Important: Do Not fold over or twist the fuel pump strainer when installing the fuel sender assembly as this will restrict fuel flow. Also, assure
that the fuel pump strainer does not block full travel of the float arm.
B. Install the fuel sender assembly (3), the retaining ring (2), and the fuel sender retaining nuts (1).
Tighten
Nuts alternately and evenly to 3 Nm (27 lb. in).
11. Install the fuel tank.
12. Add fuel.
13. Install the fuel filler cap.
14. Connect the negative battery cable.
15. Inspect for leaks.
A. Turn the ignition switch ON for 2 seconds.
B. Turn the ignition switch OFF for 10 seconds.
C. Turn the ignition switch ON.
D. Check for fuel leaks.
