Caprice Wagon RWD V8-305 5.0L (1991)
Procedure:
NOTICE:
WHEN REMOVING THE AIR INLET GRILLE PANELS, ALWAYS REMOVE THE LEFT SIDE FIRST, THEN THE RIGHT SIDE,
TO AVOID WINDSHIELD BREAKAGE.
RAISE HOOD TO FULL OPEN POSITION.
REMOVE
1 .
Hood seal using tool # J 21104-B.
2.
Wiper arm assemblies, carefully removing the plastic caps covering the 13 mm nuts and disconnecting the washer hoses.
3.
Right and left side hood seals.
4.
Left side air inlet grille, carefully removing the small rectangular cover, 7 mm cap screws and plastic push type fasteners.
5.
Right side air inlet grille, carefully removing the small rectangular cover, 7 mm cap screws and plastic push type fasteners.
6.
Perform sealing around perimeter of access hole cover using specified material (See Illustration).
IMPORTANT:
It is not necessary to remove the cover for sealing.
REINSTALL
1 .
The right side grille and retainers. DO NOT FORCE PAST WINDSHIELD DURING
INSTALLATION AS WINDSHIELD BREAKAGE COULD RESULT.
2.
The left side grille and retainers.
3.
The right and left hood seals.
4.
The hood seal.
5.
The wiper arms in proper position and torque attaching nuts to 20-26 Nm. (14 to 19 lb. ft.). Operate the wipers to insure proper operation.
6.
The plastic caps over the wiper arm attaching nuts.
Labor Operation Number:
T1606
Labor Time:
.7 Hours
