Cavalier L4-2.2L VIN F (2004)
6. Remove the 4 EBCM-to-BPMV retaining bolts.
Important:
^
Do not pry apart the EBCM (1) from the BPMV (2) using a tool. Be careful not to damage seal on the EBCM or the mating surface of the BPMV.
^
Care must be taken not to damage the solenoids when the EBCM is removed from the BPMV.
7. Separate the EBCM (1) from the BPMV (2) by carefully pulling apart.
Installation Procedure
1. Clean the sealing surface of the BPMV, with denatured alcohol and a clean shop cloth.
2. If the EBCM that was removed is being reinstalled, clean the seal and sealing surface of the EBCM, with denatured alcohol and a clean shop cloth.
3. Install the EBCM (1) to the BPMV (2). Use care when aligning the EBCM to the BPMV electrical terminals.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the 4 EBCM-to-BPMV retaining bolts. Tighten the bolts in a cries-cross pattern.
^
Tighten the bolts to 5 Nm (44 inch lbs.).