Cavalier L4-2.2L VIN F (2004)
Second Repair
4.1.
Discard the old fastener.
4.2.
Use a larger fastener GM P/N 10267482 with washer GM P/N 11500305.
4.3.
Install the SDM mounting fasteners (1).
Tighten
Tighten the fasteners to 15 N.m (11 lb ft).
5. Install the SDM wiring harness connector to the SDM.
6. Install the CPA to the SDM wiring harness connector.
7. Install the carpet and the passenger front carpet retainer.
8. Install the passenger front seat.
9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9.
10. If you replaced the SDM, perform the following procedure in order to update the BCM with the new SDM part number:
10.1. Install a scan tool.
IMPORTANT: The AIR BAG indicator may remain ON after the SDM is replaced. After programming the SDM part number into the BCM, cycle
the ignition switch OFF and ON. This turns OFF the AIR BAG indicator and clears the DTC.
10.2. Select the Special Functions option from the SIR Menu and press enter.
10.3. Select the Setup SDM Part Number in BCM option and press enter.
10.4. Follow the procedure on the scan tool display.
10.5. Cycle the ignition switch OFF and ON.
