Cavalier L4-2.2L VIN F (2004)
1. Connect the side impact sensor connector (4).
2. Install the CPA (3) to the side impact sensor connector (4).
3. Remove any dirt, grease, or other impurities from the mounting surface.
4. Install the side impact sensor to the center pillar (1).
5. Align the locating pin on the sensor to the opening in the center pillar (1).
Begin tightening the side impact sensor bolts (2).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the fasteners to 10 N.m (89 lb in).
6. Install the center pillar upper trim.
7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9 , or SIR Disabling and Enabling Zone 7.
