Cavalier/Z24 L4-138 2.3L DOHC VIN D MFI (1995)
2.
Touch-up paint as required.
b.
If condition is due to misalignment of No. 4 bow slats:
1.
Open the convertible top to the 3/4 open position.
2.
With an assistant holding the No. 4 bow up until it stops, measure and mark 177.8 mm (7.0 in.) up from the top of the No. 4 bow slat
attaching bolt at both sides of the vehicle. Measure the distance between the No. 4 bow slats and the rear rails; the distances left to right
should be equal within 1.6 mm (0.063 in.) side to side. Refer to Figure 8.
3.
Close the convertible top halfway.
4.
Standing outside the vehicle at the side which has the lesser of the two distance dimensions, push on the No. 4 bow and bend the slats until
the distances are within specification. Continually check the distances while bending the slats. Refer to Figure 9.
c.
If condition is due to protruding back belt molding attaching studs:
