Cavalier/Z24 L4-138 2.3L DOHC VIN D MFI (1995)
3. Driven sprocket (120) to shaft (132).
^ The surface that was marked during disassembly of the driven sprocket must show if it is going to be reused. This will ensure that the chain
continues to ride on the same surface. If a new driven sprocket will be installed, either surface can be placed against the shaft.
Important:
The balance shaft driven sprocket bolt is left hand threaded and must be tightened by rotating it in a counter-clockwise direction.
Notice:
A NEW balance shaft driven sprocket bolt must be used any time the bolt is removed. If a new bolt is not used, the balance shaft sprocket may
slip allowing the balance shafts to become mistimed and cause an engine vibration.
4. Balance shaft driven sprocket bolt (153) finger tight, refer to Figure 5.
5. Install balance shaft chain guide, refer to Figure 6.
6. Press chain guide tightly against the chain.
7. Tighten chain tensioner fastener (136).
Tighten
^ Bolt to 13 Nm (115 lb.in.).
8. Tighten the Balance shaft driven sprocket bolt.
