Cavalier/Z24 L4-138 2.3L DOHC VIN D MFI (1995)
specific application.
Measure (only if Installing a new IAC Valve)
Distance between tip of IAC valve pintle and mounting flange (see image).
-
If greater than 28 mm, use finger pressure to slowly retract the pintle. The force required to retract the pintle of a new valve will not cause
damage to the valve.
INSTALL OR CONNECT
1. Lubricate IAC valve O-ring with clean engine oil.
2. IAC valve assembly.
3. Attaching screws coated with appropriate thread-locking material.
Tighten
IAC valve attaching screws to 3.0 Nm (27 lb. in.)
4. Electrical connector.
5. Reset IAC valve pintle position:
A. Disconnect negative battery cable for at least ten seconds to clear PCM memory.
B. Reconnect negative battery cable.
C. Start engine and check for proper idle operation.