chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Steering|Tie Rod > < Steering Wheel - Revised Removal Procedure|Page 8613
Page 1
background image

Steering Wheel: Service and Repair

WARNING:

On models equipped with Airbags, Refer to Air Bags (Supplemental Restraint Systems) Service and Repair Disarming procedures before
performing any repair. See: Restraint Systems/Air Bag Systems/Service and Repair

1. Disconnect battery ground cable.
2. Remove steering wheel center pad attaching screws.
3. Remove inflator module.
4. Disconnect horn electrical connector, then remove steering wheel center pad.
5. Remove steering wheel retaining nut and retainer.
6. Remove steering dampener, if equipped.
7. Scribe alignment marks on steering wheel and shaft to aid installation.
8. Using tool J-1859-03, J-1859-A or BT-61-9 or equivalents, remove steering wheel from shaft.
9. Reverse procedure to install. Torque steering wheel attaching nut to 30 ft. lbs.

Steering|Tie Rod > < Steering Wheel - Revised Removal Procedure|Page 8613