Cavalier/Z24 L4-144 2.4L DOHC VIN T SFI (1996)
1. Install the module (2) to the cover (1).
2. Install the module to cover screws (3).
Tighten
Screws to 4 Nm (35 lb. in.).
3. Connect the coil harness connector (4) to the module.
4. Install the housing (6) to the cover (1).
5. Install the housing to cover screws (7).
Tighten
Screws to 4 Nm (35 lb. in.).
6. Connect the spark plug boots (8) and the retainers (9) to the housing (6).
7. Install the ignition coil and ignition control module assembly to the engine while carefully aligning the boots to the spark plug terminals.
Important: The ICM cover bolts must be installed with isolator washers with the rubber side facing down.
8. Install the ignition coil and the ignition control module assembly to cam housing bolts after coating the threads with 1052080.
Tighten
Bolts to 22 Nm (16 lb. ft.).
9. Connect the electronic Ignition Control Module (ICM) 11 pin harness connector.
10. Connect the negative battery cable.
